How to Joint an Edge with a Hand Plane

Last reviewed on 2026-10-04

Jointing an edge means planing it straight along its length and square to the face. It is needed for every glued panel and every board you square by hand. The technique is simple; what takes practice is reading what the edge is doing and correcting it with small, deliberate strokes.

Which Plane

Sharpen the iron with a very slight camber and set a medium shaving (see bench plane setup).

Step by Step

  1. Mark the reference face (the face you will check the edge against) and clamp the board edge-up in the vise, low enough to stay rigid.
  2. Check the edge first. Sight along it and lay a straightedge on it. Note high spots, and check squareness with a try square against the reference face at several points.
  3. Grip: rear hand on the tote; front thumb on top of the toe and fingers curled under the sole, rubbing against the face of the board. Your fingers act as a fence that keeps the plane centred on the edge.
  4. Take down the high spots first. If the edge is humped, take short strokes in the middle until the plane begins to cut at both ends. If it is hollow, take strokes at the ends.
  5. Then take full-length strokes: pressure on the toe at the start, even in the middle, on the heel at the end. Aim for one continuous shaving from end to end — that means the edge is straight.
  6. Check square and straight after every few strokes.

Correcting an Edge That Is Out of Square

With a slightly cambered iron the shaving is thickest in the middle of the iron. Shift the plane sideways so the middle of the iron is over the high side of the edge. Each stroke then removes more wood on that side, and a few strokes bring the edge back to square. Keep the plane flat — do not try to correct by tilting it.

Edges for Glued Joints

Match Planing

Put the two boards face to face as if closing a book, with the edges to be joined together at the top, and clamp them in the vise. Plane both edges at once. When you open the boards out flat, any small error in square cancels out because one edge leans one way and the other leans the opposite way.

The Sprung Joint

Many woodworkers leave a very slight hollow along the length, so the boards touch at the ends with a hairline gap in the middle. One clamp in the centre closes the gap and keeps the ends — where joints usually open first as the wood dries — under pressure. Make it with two or three stopped strokes in the middle of the edge before a final light full-length pass. Keep it slight: if it takes more than moderate clamp pressure to close, plane it straighter.

Checking the Fit

Stand one board on the other in the vise. It should balance without rocking, and the joint should close with no light showing (or only the slight, even gap of a sprung joint). Check that the faces line up flat across the joint with a straightedge.

Common Problems

Frequently Asked Questions

How do you plane the edge of a board straight?

Use a long plane, take down high spots with short strokes first, then take full-length strokes with pressure on the toe at the start and the heel at the end, until you get one continuous shaving.

How do you keep the edge square to the face?

Use your front fingers under the sole as a fence, check with a try square often, and correct by shifting a slightly cambered iron over the high side of the edge.

What is match planing?

Planing two boards' edges together while clamped face to face. When unfolded, any small angle error in the edges cancels out and the joint closes flat.

What is a sprung joint?

An edge joint with a very slight hollow along its length so the ends touch first; a single clamp in the middle closes it and keeps the ends tight.